I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
Using nRF51822, I define keys and pins as follows:
Keyboard key
Mouse left/right key
Mouse move (up/down/left/right)
Media play/pause key
Pin 0 Mouse...
In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4
network.
The tunnel broker is providing IP conversion service with 6in4.
Preparation
Raspberry Pi…
###Other relevant posts
A concise guide to equipment setup, and how to use the development kit for current measurements can be found here: Measuring current with PCA10040 v0.9.0
A post that describes…
When designing a PCB with nRF51, nRF51822 or nRF51422, there are some rules that should be followed in order to get a good working radio/system, with a maximized range.
General rule
The RF part of the…
2019-02-08: Updated tutorial to cover nRF5 SDK version 15.2.
Introduction
Scope
The following topics will be included in this tutorial:
Configuration of the Scheduler library.
Using the scheduler with…
Scope
Topics that will be covered include:
Before we begin
Necessary equipment and software
Necessary prior knowledge
Setting up the example projects
Background theory
Central and peripheral roles…
2018-11-23: Updated tutorial to cover SDK version 15.2.
2019-02-08: Improved example project (SDK 15.2) and updated instructions accordingly.
Introduction
Scope
The following topics will be included in…
Before we begin
Scope
Topics that will be covered include:
Before we begin
Necessary equipment and software
Necessary prior knowledge
Some basic theory
The Generic Attribute Profile (GATT)
Services…