Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
radio_test_example 0

Hi, Is that possible to run the radio_test_example (\nRF51 SDK_v5.2.0.39364\Nordic\nrf51822\Board\nrf6310\radio_test_example) on the nRF51822EK? If yes, what modifications...
- dtm
- radio_test_example
867 views

0 replies

Started over 10 years ago
by Rocky Liang
Not Answered

we developing a audio shockburst transmiter for nRF24LE1 but ADC not working correctly both mode conditinuse or step 0

we also produced self PWM for ADC wave form testing. when we stop transmission, we will get good waveform out, but when we starting transmission, output waveform shape is...

574 views

0 replies

Started over 10 years ago
by TKS
Not Answered

S120 Problem on eval board 0

Dear Support, I have some troubles with the Evaluation Kit for nRF51822 : I use the broad as a central role with S120_nrf51822_1.0.0_softdevice.hex and example...

554 views

0 replies

Started over 10 years ago
by Winstone
Not Answered
nRF9E5 Rx behaviour when CRC fails 0

Suppose a nRF9E5 transmitter is set for continuous transmission on a channel. A nRF9E5 receiver listening on that channel: finds carrier and sets CD finds address...
- nrf9e5
591 views

0 replies

Started over 10 years ago
by Damien
Not Answered
How to discover center Service from peripheral? 0

Between connect to center ,how can I get the service of center?
- sdk6.0
- s110
- uuid
- nrf51822
660 views

0 replies

Started over 10 years ago
by gootoomoon

Recent in Nordic blog

Developing Nordic nRF51 applications with mbed and Visual Studio

ivan

This tutorial shows how to use the mbed framework to develop applications for Nordic nRF51 devices. Before you begin, install VisualGDB 5.1 or later. Start Visual Studio and open the VisualGDB Embedded…
- 26 Jan 2016
PA / LNA support in S132

Einar Thorsrud

The S132 SoftDevice for the nRF52 has support for enable/disable switching of external Power Amplifiers (PA) and Low Noise Amplifiers (LNA) using GPIO pins. This was introduced in S132 version 2.0.0-7…
- 25 Jan 2016
Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016
SEGGER Embedded Studio Part 2 - Monitor Mode Debugging

Michael Dietz

This tutorial will take less than 15 minutes. #Motivation Never lose a BLE connection when debugging your applications again! This technique will also be useful for any application using the PWM peripheral…
- 22 Jan 2016
An introduction to error handling in nRF5 projects

Audun

As you start developing with the nRF5 series chips, SoftDevices, and SDKs, it's very useful to learn how errors can be discovered (and preferrably recovered from). This can be detecting something as simple…
- 20 Jan 2016