Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
Obligatory Disclaimer
Security is hard. If a product handles sensitive information then it is the engineer's responsibility to his customers to consult a security professional. However, experimenting…
Communicating with Ultrasonic Distance Sensor HC-SR04 using nRF51-DK (nRF51822/nRF51422), and transmitting measured distance over BLE UART.
http://electronut.in/nrf51-hcsr04/
The nrf52832 is quite a competent System on Chip. Even with the long list of errata for the preview release this chip packs a punch.
I've been playing around with this chip for sometime now and have made…
Recently, there are a few queries from Japanese customers on nRF51 production.
Basically the expectations are
- Program the flash as a whole, including bootloader, application and soft device
- Target…
Introduction
This blog will aim to give you an understanding of the zip package required to perform a Device Firmware Upgrade of your device. This blog will apply to the newest tools available to do this…