Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered

PAN item 56 TWI module lock-up problem and Rev 3 version of the chip 0

Hi, Will PAN item #56 TWI: TWI module lock-up be fixed in the Rev 3 version of the nRF51822/51422? Also would you happen to have a time frame as to when the Rev 3 will...

902 views

0 replies

Started over 11 years ago
by ray
Not Answered

Why does re-connection occur 2 times？ 0

Close Bluetooth in Iphone's settings when IOS/51822 is paired and connected normally. several seconds later, Open Bluetooth in the settings again, and observe the settings...

690 views

0 replies

Started over 11 years ago
by ziv
Not Answered

NRF_WDT: Not able to write to registers 0

Hi, I am trying to power off and/or disable a RR[0] with no success. I am Powering OFF the watchdog in main and then successfully POWERing ON in wdt_init but then I...

1256 views

0 replies

Started over 11 years ago
by Fab
Not Answered

Limit number of packets per connection event? 0

Is it possible when using the S110 softdevice to limit the maximum number of packets per connection event? I would like to reduce the maximum amount of time the CPU spends...

1132 views

0 replies

Started over 11 years ago
by Paolo D
Not Answered

ANTUSB-m Dongle not working with Windows 7 0

I am using nRF51422 Evaluation Kit with the latest silicon revision which comes with programmable softdevice. The kit also contains an ANT USB-m dongle. I have followed the...

732 views

0 replies

Started over 11 years ago
by Vamsi Talla

Recent in Nordic blog

Developing Nordic nRF51 applications with mbed and Visual Studio

ivan

This tutorial shows how to use the mbed framework to develop applications for Nordic nRF51 devices. Before you begin, install VisualGDB 5.1 or later. Start Visual Studio and open the VisualGDB Embedded…
- 26 Jan 2016
PA / LNA support in S132

Einar Thorsrud

The S132 SoftDevice for the nRF52 has support for enable/disable switching of external Power Amplifiers (PA) and Low Noise Amplifiers (LNA) using GPIO pins. This was introduced in S132 version 2.0.0-7…
- 25 Jan 2016
Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016
SEGGER Embedded Studio Part 2 - Monitor Mode Debugging

Michael Dietz

This tutorial will take less than 15 minutes. #Motivation Never lose a BLE connection when debugging your applications again! This technique will also be useful for any application using the PWM peripheral…
- 22 Jan 2016
An introduction to error handling in nRF5 projects

Audun

As you start developing with the nRF5 series chips, SoftDevices, and SDKs, it's very useful to learn how errors can be discovered (and preferrably recovered from). This can be detecting something as simple…
- 20 Jan 2016