Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
RTT viewer logging doesn't show device log on custom application. 0

We tried to see device logs from our target. We use dfu bootloader for our custom target. I enable RTT logging on our custom source for our target. Then we can see...
- development
- software
- nRF52833
- dfu
14 views

0 replies

Started 2 hours ago
by bini2007
Not Answered
Changing the name of a custom BLE GATT service? 0

I tried used Nordic's UART service implementation as a starting point and everything works but I can't figure out where the string "Nordic UART Service" from "nrf connect...
17 views

0 replies

Started 6 hours ago
by olalonde
Not Answered
Stack Crash when used psa_ps_set (not */ns build) to store a certificate 0

Product: nRF54L15, SDK: V2.9.0 Application: Matter + BLE multi-protocol Hi, we want to store X509 certificates in secure storage. I went went through Nordic supplied...
16 views

0 replies

Started 6 hours ago
by SubuMuthu
Not Answered
PaWR power consumption 0

Hi, MCU - nRF52832 I am trying to understand the power consumed during the PaWR operation. I am referring to the steps explained here: I am getting the a similar graph...
23 views

0 replies

Started 7 hours ago
by Katy_123
Not Answered
nRF9161 DECT NR+ - hello_dect sample issue 0

Hello, I am using Zephyr Toolchain v2.9.0 on an nRF9161 custom board . I have updated the modem firmware to mfw-nr+_nrf91x1_1.0.2 and flashed the board with the hello_dect...
27 views

0 replies

Started 9 hours ago
by Vaban

Recent in Nordic blog

Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015

Latest guides

Bluetooth low energy: Bluetooth Smart and the Nordic's Softdevices - Part 1 GAP Advertising

Hung Bui

This blog series was created as an attempt to fill in the gap between how Bluetooth Smart is defined in the spec and how you can use our APIs and event from our softdevice to do what defined in the spec…
- 10 Dec 2015
nRF5x: Current measurement guide: Introduction

Stian Røed Hafskjold

###Other relevant posts A concise guide to equipment setup, and how to use the development kit for current measurements can be found here: Measuring current with PCA10040 v0.9.0 A post that describes…
- 1 Dec 2015
nRF5x: General PCB design guidelines for nRF51 series

Petter Myhre

When designing a PCB with nRF51, nRF51822 or nRF51422, there are some rules that should be followed in order to get a good working radio/system, with a maximized range. General rule The RF part of the…
- 13 Nov 2015
Software Development Kit: nRF5 SDK Scheduler Tutorial

Einar Thorsrud

2019-02-08: Updated tutorial to cover nRF5 SDK version 15.2. Introduction Scope The following topics will be included in this tutorial: Configuration of the Scheduler library. Using the scheduler with…
- 9 Nov 2015
Bluetooth low energy: Bluetooth low energy central tutorial

Anders Strand

Scope Topics that will be covered include: Before we begin Necessary equipment and software Necessary prior knowledge Setting up the example projects Background theory Central and peripheral roles…
- 4 Nov 2015
Software Development Kit: nRF5 SDK Application Timer Tutorial

Einar Thorsrud

2018-11-23: Updated tutorial to cover SDK version 15.2. 2019-02-08: Improved example project (SDK 15.2) and updated instructions accordingly. Introduction Scope The following topics will be included in…
- 30 Oct 2015