Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
High duty cycle for regulatory testing? 0

Hi, We're at a point in our project where we're working through some regulatory testing for ETSI/FCC certifications with our BLE dongle board (nRF52840 + nRF21540 FEM...
25 views

0 replies

Started 15 hours ago
by Hale Knox
Not Answered
System ON Sleep Mode 0

Hi, I'm using zephyr RTOS. I'd like to put the cpu System ON Sleep Mode to conserve power. Then, I'd like to restart the CPU with an interrupt or event from the comparator...
19 views

0 replies

Started 16 hours ago
by Jim Logsdon
Not Answered
customize the Nina AoA C2909 Nina TAG 0

Dear Staff, we have some Ublox C2909 TAG based on your nRF52833 chip.We need to program them for an RTLS project. In particular we need to: customize the FW here ...
18 views

0 replies

Started 17 hours ago
by NCKGTW
Not Answered
Channel Sounding – Ranging Data Overwritten and No Distance Update 0

Hello, I managed to run the examples for nrf54l15 channel_sounding_ras_initiator.c and reflector on my custom hardware boards. I changed the overlay files to use my own...
34 views

0 replies

Started 1 day ago
by witc
Not Answered
Question about SPIM00 in NRF54L15-DK 0

SDK: nRF Connect SDK v3.0.2 The green line is SCK, yellow is CS. Why is the voltage of the SCK so low? And the signal is not a square wave.
36 views

0 replies

Started 1 day ago
by Leo Mo

Recent in Nordic blog

Programming the nRF51822 Beacon Kit with the nRF51DK

Stefan Birnir Sverrisson

One way to program the nRF51822 Bluetooth Smart Beacon Kit is to use the nRF51 DK. This gives you a full scale development platform (the nRF51 DK). This blog will go thru the steps needed to program…
- 7 May 2015
Bluz, a cloud connected Bluetooth LE development kit based on the nRF51822, is live on Kickstarter

eric ely

Bluz is a brand new development kit that brings Bluetooth LE to the internet. We have paired up with Spark and ported their FW to the nrf51822, allowing Bluz to be controlled and programmed over the…
- 15 Apr 2015
nRF51 current consumption for common scenarios

Stefan Birnir Sverrisson

The following is the estimated nRF51 current consumption during advertising with the DCDC disabled. Advertising 1: TX power: +4dBm adv interval: 20ms (minimum advertising interval in normal adversising…
- 14 Apr 2015
Building kernel for RPi2 with bluetooth_6lowpan for Raspbian

Håkon Alseth

Building kernel for RPi2 with bluetooth_6lowpan In this guide, you will have two choices: Cross-compilation build Native build Choose the one that fits your needs. Cross-compilation is…
- 9 Apr 2015
Debugging with Real Time Terminal

FormerMember

In SDK 12.0.0 or later, logging/debugging over RTT is built in to the logger module NRF_LOG. To enable logging over RTT, "check" the NRF_LOG_BACKEND_SERIAL_USES_RTT option in sdk_config.h in the configuration…
- 8 Apr 2015
Accessing the BLE mesh via the particle.io (spark.io) cloud

David Edwin

Hello. I was spending the last few days to implement an interface to access the BLE mesh via the Internet. The mesh consists of devices with LEDs, which then could be turned on and off in my browser.…
- 1 Apr 2015