Hello, I am using the nRF54L15 board, and trying to connect to the Adafruit SHARP 400x240 monochrome LCD display .
I got the display driver alone to function just fine after...
Hi,
I am trying to perform a DFU using SMP over BLE. My setup has NSIB and MCUBoot enabled and thus I am able to perform DFU for MCUboot and Application using nrf device...
Hi all,
I'm trying to use uart2 on my custom nrf9151 board, but I'm stuck. As I understand, I use i2c1 so I can't use uart1 and i2c1in parallel, so here is why I wnt to...
Hi - I am seeking clarification on a topic as I am a little unsure on the correct way to do things.
I'm using an nRF52840 and porting an old Firmware from nRF5 SDK to NCS...
Hello,
I'm moving my project from SDK1.9.1 to SDK3.0.2. Project is based on peripheral_uart sample (UART part is removed since it is not necessary).
I have encountered...
If you are looking for a place to get started with DFU, please have a look at this presentation here and the tutorial here.
In this post, we cover some in depth Q&A topics regarding Device Firmware…
One way to program the nRF51822
Bluetooth Smart Beacon Kit is to use
the nRF51 DK. This gives you a full
scale development platform (the nRF51
DK). This blog will go thru the steps needed to program…
Bluz is a brand new development kit that brings Bluetooth LE to the internet. We have paired up with Spark and ported their FW to the nrf51822, allowing Bluz to be controlled and programmed over the…
The following is the estimated nRF51 current consumption during advertising with the DCDC disabled.
Advertising 1:
TX power: +4dBm
adv interval: 20ms (minimum advertising interval in normal adversising…
Building kernel for RPi2 with bluetooth_6lowpan
In this guide, you will have two choices:
Cross-compilation build
Native build
Choose the one that fits your needs. Cross-compilation is…
In SDK 12.0.0 or later, logging/debugging over RTT is built in to the logger module NRF_LOG. To enable logging over RTT, "check" the NRF_LOG_BACKEND_SERIAL_USES_RTT option in sdk_config.h in the configuration…
