Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Error "Invalid ROM table" when erase or download (nrf52810) 0

I'm building my small board with nrf52810, buyed 10 chips from seller, it is cheaper relatively, I know it is used chip. 7 of them burned successfully,but 3 of them raise...
116 views

0 replies

Started 2 months ago
by OldXiao
Not Answered
NRF_RADIO_MODE_BLE_LR125KBIT 0

Hello Nordic, I’m using ncs\v3.1.0\nrf\samples\peripheral\radio_test` to test the nRF54L15 with PHY set to `NRF_RADIO_MODE_BLE_LR125KBIT`. However, the RF spectrum measurement...
138 views

0 replies

Started 3 months ago
by masa
Not Answered
cannot read (in central) the 2nd custom characteristic value defined within a custom service (of a peripheral) 0

Dear Nordic Experts, Hello, i have defined a custom service containing a custom char. value in a peripheral according to https://github.com/NordicPlayground/nRF5x-custom...
94 views

0 replies

Started 3 months ago
by Ataei
Not Answered
Please cancel this ticket 0

Please cancel this ticket
- nRF9151
212 views

0 replies

Started 4 months ago
by zpm1066
Not Answered
I2S Master Frequency Stuck at 10 kHz 0

Hi there, This is a follow up post from my earlier one here about using nRF5340 dk as an I2S master for the purpose of recording sound using a MEMS sensor ICS43434. Here...
148 views

0 replies

Started 4 months ago
by umer

Recent in the DevZone Blog

Comparing compilers/IDEs for development with nRF5x series devices

Michael Dietz

#Introduction All compilers ARE NOT created equal. Given the same c code, different compilers will generate machine code with varying performance & size. Generally the more efficient machine code (uses…
- 28 Jan 2016
nRF52 Range Extension with RFaxis' RFX2411N

Floyd Ashbaugh

External Power Amplifiers and LNAs easily connected to the nRF52 series device for high power extended range operation. Data sheets, white papers, schematics and layout information available at link t…
- 26 Jan 2016
Developing Nordic nRF51 applications with mbed and Visual Studio

ivan

This tutorial shows how to use the mbed framework to develop applications for Nordic nRF51 devices. Before you begin, install VisualGDB 5.1 or later. Start Visual Studio and open the VisualGDB Embedded…
- 26 Jan 2016
PA / LNA support in S132

Einar Thorsrud

The S132 SoftDevice for the nRF52 has support for enable/disable switching of external Power Amplifiers (PA) and Low Noise Amplifiers (LNA) using GPIO pins. This was introduced in S132 version 2.0.0-7…
- 25 Jan 2016
Step by Step Guide to Setup and Start Developemt with nRF51 or nRF52 DK and IAR

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, to get the necessary tools installed and get the software (SW) development…
- 25 Jan 2016
BLE nrf51 - Multilink NUS central - Connect to many peripherals through NUS service - with Arduino host

Marco Russi

Hi all, I implemented a simple multilink NUS central based on s130 for nrf51 chip-set. It means that this NUS central can connect to several peripherals simultaneously and send data to each one of them…
- 24 Jan 2016