Description : It is not possible to flash or debug an application with IAR on the Nordic target. This issue is caused by a bad interaction between CMSIS-DAP IF present on...
Hi,
What should i do after i load mesh app in " github.com/.../nRF51-ble-bcast-mesh" adress?i have two board
When i download the app,why doesnt advertising exist.i cant...
hello
i am using the Nrf52dk with Visualgdb.
i try to run the example project (tcp/IP -> client).
i am using the Nrf5 IoT sdk v0.9
Project complied successfully but i...
The nRF9160 SiP supports the use of both LTE-M and GPS. We want to show how these can be used in an application at the same time. In this project we demonstrate this by using the nRF9160 DK to send the…
This blog post contains answers to questions asked during the "Introduction to nRF Connect SDK" webinar hosted by Nordic Semiconductor 25.09.2019.
You can watch a recording of the webinar her…
It's been a month since we last spoke, when we announced the release of nRF Connect for iOS 2.0. What a day that was, wasn’t it? In any case, we’re here because, since then, we’ve made three successive…
Background
There is a need to enable Nordic hardware with the Direct Test Mode (DTM) firmware. This is so the physical layer and RF characteristics may be ascertained as set in the Bluetooth Sig Specification…
Requirements
This document uses:
Segger Embedded Studio (SES)
nRF5 SDK v17.1.0
an nRF52 DK to emulate the nRF52810
a BLE-enabled mobile device
You may want to review the blog here for a more comprehensive…
Requirements
This hands-on tutorial uses:
Segger Embedded Studio (SES)
nRF5 SDK v17.1.0
an nRF52840 DK
a BLE-enabled mobile device
You can use an nRF52 DK or nRF52833 DK instead of the nRF52840 DK,…
This is part 3 of the series Building a Bluetooth application on nRF Connect SDK
You can find other parts here:
Part 1 - Peripheral Role.
Part 2 - Central Role.
In Part 1 we covered the generic architecture…
Purpose
The purpose of this guide is to demonstrate the use of Bluetooth Shell. Bluetooth Shell (BT Shell) is a command-line shell application that runs over the UART. It allows one to manually type in…
Out of the box, the examples in the nRF Connect SDK are configured for ease of use, functionality, and debugging; they are not generally configured for optimal memory utilization. Some of the examples…