Hi.
After migration from SDK2.7.0 to SDK2.9.0 I have issues with power mangement. CONFIG_PM_DEVICE_RUNTIME=y, which I used, causes that twi driver doesn't start. I try to...
Hello everyone.
I am developing a custom board using the nRF9160. I tried using the RAM power-down library based on the Power optimization recommendations page of the nRF...
Since the nRF9160 reserved pins are never used, Is there any issue leaving them out of the footprint?
I would place copper keepouts under the reserved pin areas to ensure...
Is it possible to get to port of an UDP socket (ephemeral, offloaded to modem) with NCS 2.9.0 and mfw 2.0.2?
I tried "getsockname" and get "errno 95 (Operation not supported...
I am trying to use an ESP8266 ( ESP-01) to add Wifi capabilities to a nRF9160 project board. I am using nRF Connect SDK V2.9.0 and the V2.9.0 Toolchain.
To set it up I followed...
I recently blogged about Nordic and Hackathons, but didn't include too much information; I knew already there was something coming. And now it is finally published: #HackDublin - Ireland's First Design…
Today, QuickLogic announced the availability of our TAG-N Wearable Sensor Hub evaluation kit for the Nordic Semi nRF51 DK, Nordic’s all-in-one, multiprotocol development kit for ultra-low power wireless…
Recently we introduced support for CMSIS-Pack into our nRF51 SDK. The nRF51 SDK is natively supported in the Keil IDE. This means that nRF51 SDK latest version and example software for nRF51 are easily…
Purpose
The purpose of this blog is to showcase how a single USB bus can be used as the physical transport for multiple protocols when an external CPU is the controller.
Specifications as tested
Boards…
Table of Contents
Objectives
What are device tree overlays, and how do they relate to shields?
Why are Arduino nodes not recognized in the nRF9160 DK?
The workaround: Using the shield as a board ove…
Table of Contents
Hardware
Components
Wiring
Software
Prerequisites
Steps
Incorporating this into other projects
Further reading
Attached files
This blog post demonstrates how to get a LVGL sample…
Background:
There is a need to be able to put a Nordic Semiconductors S0C /transceivers into modes where the physical layer and RF characteristics may be ascertained. The radio test example is used to…
This is part 2 of the series Building a Bluetooth application on nRF Connect SDK - Contrasting to SoftDevice based Bluetooth applications
You can find the other parts here:
Part 1 - Peripheral Role.
Part…