Due to production requirements, I need to obtain the device's QR code. However, I found that the QR code can only be retrieved using the code snippet below after calling Nrf...
I am trying to create a custom sensor for CT1711 temperature sensor. I have created the sensor driver code and device tree binding, but it won't start (initialize) and the...
Hi,
Is it possible to make the MQTT connected device receive the Shadow config updates and AT Commands immediately? Based from our testing, the device only receives the...
Hi Nordic Support Team,
I'm currently experimenting with Channel Sounding using a couple of nRF54L15 boards.
I am trying to obtain raw I and Q samples so that I may analyze...
Hello,
currently i am configuring the networking stack on my project.
The goal is to use Matter's built-in Thread connection, to establish a Secure CoAP connection. I...
In this post, we try to setup OpenWRT on a Japanese router, Buffalo WZR-600DHP, which has a Atheros AR7161 in side. The officail guide by OpenWRT could be found here:
http://wiki.openwrt.org/toh/buffalo…
It's an old chestnut the pairing conundrum, how to make it safe and secure yet so simple people aren't left confused and frustrated whilst trying to pair products. Bluetooth Smart currently has 3 pairing…
When I decided to attempt the reprogramming of my nRF51822 Beacon Kit I read several posts related to the task. The information I needed was there but I found it to be a bit scattered. It was difficult…
The Infocenter – our new documentation portal - has now been up and running since June and contains all of our technical documentation. We saw the need for this because we wanted to make our complete…
We recently announced that we now support “extended industrial temperature range” (-40 – 105C) on our nRF51822.
The devices supporting -40 - 105C are the QFAA (QFN with 256kB flash and 16kB RAM) and the…
Introduction
Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…