running Windows 10 Pro 22H2 and using j-link v9
i tried to read firmware from nrf51822-QFAB by using " nrfjprog --readcode dump_nRF51822.hex", but it gave me an error...
Hello,
We have an NCS v2.2.0 nRF5340 application with MCUboot that requires GPIO control of a few pins extremely early in the startup process. We have a signal "A" pulled...
Sorry if this is too off topic, I actually don't have any problem with my nrf52840 dongle, but the App I'm communicating with. But maybe someone of you has run into the same...
Nordic Developer Zone - The Nordic developer’s best friend
The original goal of Nordic Developer zone was to create a resource for our customers that would complement direct Nordic technical support.…
Introduction
This example shows a simple GPIO driver for seamless handling of the GPIO and GPIOTE peripherals of the nRF52 series. This example is particularly intended for developers who wish to develop…
TL;DR
If you just want to navigate (without debugging) through the nRF5-SDK using CLion, follow the following steps. For debugging go to “Debugging the nRF52 with CLion” in the full post.
(optional…
Before we begin
Table of context
Before we begin
The "Hello world" example
Advertising
RSSI
Addresses
Address types
Advertising types
Bonding
Advertising data
Scan response data
Change Log 2018…