Problems building Direction_finding_central sample

[johan_1234]

Hi, I recently installed the last version of the SDK v2.5.2 and when I try to build the sample direction_finding_central  I am getting the following error

I am running this command to build

west build -b nrf52833dk_nrf52833 -- -DCONF_FILE=prj.conf

the other sample, direction_finding_peripheral builds without problems, and other samples also.

Is there a special configuration for building this sample?

I will need the AoA mode only, however as I understand there is no need to use the overlay for this.

On VsCode I get this warning



I think this may be related since the callback cte_report_cb in the conn.h has a condition that only enables if the CONFIG_BT_DF_CONNECTION_CTE_RX=y

Any help would be greatly appreciated.

[johan_1234]

Hi, not really. Because I am more interested in getting IQ measurements with an antenna array, I switched to the connectionless sample and its what I am using now.

[Elfving]

Hello Yang,

So this is the default sample, without anything modified? What board are you building it for?

Regards,

Elfving

[Zihao]

Hi, the connectionless sample is working well but doesn't meet my requirement [sad]. Thank you for your reply.

[Elfving]

I am sorry to hear that.

Zihao said:

Hi, the connectionless sample is working well but doesn't meet my requirement [sad]. Thank you for your reply

Im still adamant about the connected sample working though, if you want to discuss that further.

Regards,

Elfving

[Zihao]

Yes, I built the default Direction_finding_central without anything modified and then I got this error. My target board is nRF52833DK with an antenna array designed by Nordic.

Regards,

Zihao