nRF52840 Thread communication performance test

[rei.n]

I would like to perform a test to confirm the receiving characteristics of the nRF52840.
When I looked at the RF Performance Test Guidelines White Paper, I believe it said, "How to make this sensitivity measurement test firmware on a simple MCU is described for each nRF device in the nRF performance test instructions." However, when I checked the nRF52 series documentation, I was unable to find any materials describing how to test the performance of the MCU.
If there are any materials that describe how to test the performance of the nRF52 series, I would appreciate it if you could let me know.

[rei.n]

Hi Hung,

I am currently trying to make the radio test command available on the nRF52840DK, but have not been able to do so.
I apologize for asking such a basic question, but if there is any documentation that explains how to use the radio test command on the nRF52840, I would appreciate it if you could let me know.

[Hung Bui]

Hi, 
Have you flashed the sample on a nRF52840. After you flashed the sample , you can open UART and can see this log. From that you can type "help"  to see the list of command: 


After that you can call start_rx for example to start receiving test. 
The testing steps can be found in the radio test documentation: 

[rei.n]

Hi Hung,

I'm sorry, but I didn't flash the sample.
I'm sorry, but if there is any documentation on how to flash the sample, I would appreciate it if you could let me know.

[Hung Bui]

Hi, 
If you are not familiar with Nordic software development platform, I would suggest to take a look at our Developer Academy nRF Connect SDK fundamental course here: https://academy.nordicsemi.com/courses/nrf-connect-sdk-fundamentals/lessons/lesson-1-nrf-connect-sdk-introduction/

You should complete at least Lesson 1 to be able to build and flash the radio test sample. 

It would be easier if you can get help from a software developer that's more familiar with Nordic's SDK to build and flash the radio test. 

[rei.n]

Hi Hung,

Understood.
Thank you for introducing the documentation.
I will try flashing the sample following the documentation you provided.
I will be happy to answer any further questions if I have any.