How can I execute a command to commission a device for Thread by using the QR code or pairing code?

[paper555]

How can I execute a command to commission a device for Thread by using the QR code or pairing code? (without using the pin_code or discriminator) Thanks.

[Amanda Hsieh]

Are those Matter devices already present in an IP network? If so, you can commission them with QR code payload or manual pairing code.

[paper555]

This is a matter over thread device, the OTBR is built on the Raspberry PI environment, and the chip tool runs on the Raspberry PI. How to make this purchased matter over thread join the ip network, or what commands should I use to make this device join the ip network ? 

[Amanda Hsieh]

Please contact your provider.