Request for Assistance with Initial Setup of IDE for Development

[Shubham Singh]

Dear NRF Team,

I hope this message finds you well. I have been following the steps provided at the Dev Academy for the initial setup of the IDE. However, I have encountered different errors when attempting to use both Visual Studio and Segger IDEs. Despite my repeated attempts over the last two weeks, I have been unable to resolve these issues and proceed with my development work.

I would greatly appreciate it if you could provide me with guidance or the necessary resources to ensure a proper setup so that I can start my development. I am stuck at this point and would be thankful for any support or advice that could help me move forward.

Looking forward to your prompt assistance

[Asbjørn]

Hello Shubham,

I want to assist you and get you going, but you will have to share a bit on what you have and haven't done. I see some copied errors from somewhere, but I don't know at what stage or what you were trying to do. 

https://academy.nordicsemi.com/courses/nrf-connect-sdk-fundamentals/lessons/lesson-1-nrf-connect-sdk-introduction/topic/exercise-1-1/ How far along did you get on this tutorial? There are numbered steps that would give me some information as to what you have been able to successfully do and where it stops. Which SDK selection did you go for. Did Segger softwar install? did you download an install the nRF comamnd line tools? nrfutil? Extensions for VS code, did they install correctly? Install toolchain?

Best regards

Asbjørn