This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

nRF52832 "unable to connect to the target"

Hi!

I have an nRF52832 on a custom board. I managed to flash it through JLink and STLinkv2. But suddenly, I wasn't able to communicate to it anymore.

Openocd tells me: "unable to connect to the target".

So I measured all the internal reference voltages at respective pins and they're all okay at 1.28V. External voltage is at 3.3V as expected. The reset pin stays at 1.5V even during the flashing process and doesn't move even a bit, even tho the reset pin is pulled down to ground with a resistor.

Does anyone have an idea what I could be doing wrong and tell me?

Thanks! Best regards Yatekii

Related