nRF5 temperature example uart problem

[walterLIte]

I cannot get the output from the is the example the UART buffer gets filled but there is no output to the tty.

The interrupts seem to be set, but I don't see the interrupt routine so there is no way that I can debug this

Any help would be appreciated

Thank you

[endnode]

No no no my dear friend, there are only PCA10040 and PCA10056 targets in SDK v14.0.0 and these are indeed (similar to PCA10036) all nRF52 targets (as you can learn when opening them or on Nordic Infocenter here, here and here). Yes, PCA10028 is nRF51 DK but there is no pre-compiled or prepared project for it since SDK v13.0.0 that's why I asked what do you use. Regarding RTOS vs. "bare metal" I meant if you use SoftDevice (which is RTOS on its own) or not (rather then any freeRTOS or similar inside your app part) (1/2)

[endnode]

(2/2) ... but you are right, nRF5_SDK_14.0.0_3bcc1f7\examples\peripheral\temperature project as all the rest in nRF5_SDK_14.0.0_3bcc1f7\examples\peripheral folder doesn't use any of them. So now back to your question: you wither don't use nRF5 SDK v14.0.0 (because there is no project nRF5_SDK_14.0.0_3bcc1f7\examples\peripheral\temperature\pca10028) or you don't use PCA10028 target. Btw. once you settle down on what version you use (I recommend to stick with SDK v12.3.0 which is the last one officially supporting nRF51) I recommend to make the project work on genuine nRF51 DK board (PCA10028) or similar. Once you are sure that everything is under control then you can move to custom/different module easily.

[walterLIte]

I was wrong was using SDK 11 now switched to nRF5_SDK_12.2.0_f012efa with the same error result, unfortunately

[endnode]

OK, so logical step back would be: are pre-compiled examples working for you on nRF51 DK?

[walterLIte]

ah ...the struggle continues !!! steep learning curve