RTC Inaccuracy

[Dave_couling]

I'm finding fairly large lags with the RTC2 I'm using. I use an app_timer to sample the current RTC count value as a timestamp (MM:SS:Hundredth-of-a-second) and send it out via an HVX. However I'm noticing after about 2mins the RTC is lagging a reference time by almost a second. I have set the prescalar to 327 (to get ~10msec resolution), to capture fractions of a seconds. I don't use the interrupts except for on overflow, so I know its not an interrupt lag from a BLE event. Could the BLE traffic really interrupt my RTC counter get function enough to cause this drift?

I'm really at a loss how to get accuracy (millisecond) timestamps for HVX transmissions, almost seems impossible on this chip.

[RK]

No the BLE traffic doesn't impact the RTC2 counter in any way. It's hardware. So what's your LF clock source for a start, how accurate is that? Given your use of 327 you should be lagging about 1/4 second after 2 minutes. So how accurate is your 'about 2 minutes' and how accurate is your 'almost a second'? Because if it's really 4 minutes and it's really 1/2 second .. that's about to be expected.

You should set up a bare board test of your clock source outputting to a GPIO using hardware, PPI whatever you have and measure with some kind of signal analyser. In fact you could fairly easily add the PPI GPIO toggle to your current implementation and count rollover times or something, that will give you a reasonable way of determining what the RTC is counting.

You seem to have inordinate difficulties with something very simple, both using the RTC and the HF clock (I saw the last post). It really shouldn't be hard at all.

[Dave_couling]

Yes, an I've verify similar inaccuracy with the RTC. However the inaccuracy is affected by BLE traffic. Testing with different connection parameters and data transfer rates, sampling the RTC rarely so as to not be affect by BLE interrupts, I see variance between 1-4sec per minute. Worse with high BLE data thru put.