Best practice for monitoring coin cell battery voltage given ESR

[David]

I'm using an NRF51 w/ S130 operated directly from a coin cell battery. I use the ADC with a voltage divider to successfully measure analog voltages. One of the challenges of the coin cell is that its ESR is not insignificant and degrades overtime. This means that if I have a substantial current pulse (for example from RF activity) the battery voltage droops in a meaningful way (sometimes ~200 mV). The ESR is not fixed and usually gets worse over time. Suppose my system cannot operate below 2.4V and I want to monitor the battery voltage and [do something] when there's a low battery condition. What's the best way to do this given the ESR? For example with a multimeter I might see "2.6V", but with a healthy current pulse the battery might actually droop to 2.4 momentarily, which could brownout my system. Is there a way to synchronize sampling the ADC with RF activity so I can measure the worst case battery voltage?

[David]

That's interesting -- the spikes I see are an order of magnitude lower than that, but I suppose I could try the same technique with more realistic currents. I assume your suggestion is that once I have the ESR I can know what my max current spike at some nominal voltage is, and infer a V_drop based off this value and the ESR. I see a few potential problems with this: 1. the battery is user replaceable and different batteries have different ESRs (I've found massive differences between different brands) and 2. it seems like to make this work I'll have to be quite conservative and potentially leave a lot of battery life on the table.

Is there a way to sample the ADC while the radio is transmitting? It seems to me like this is the cleanest solution.

[rct42]

@David: I'm probably misinterpreting your situation, but you don't need a voltage divider for measuring the battery voltage (when your microcontroller is connected directly to the coin cell) using the aforementioned technique. On the issue of sampling when the transmit is occurring, have a look into the "Radio Notification Events Handler". If this doesn't work out, you could always connect an unused GPIO to VDD_PA and configure the GPIO to interrupt on state changes.

[Bjørn Kvaale]

Talked to an expert here at Nordic and it should be possible to use the ADC while the radio is transmitting. As you are using the nrf51, you will get a lower ADC sample rate with a lot of radio activity, as the nrf51 does not have easyDMA (the nrf52 does). On the nrf51, you will need to communicate with the cpu to get the voltage measurements from the ADC. Since the radio uses the CPU for transmission, the sampling rate of the ADC will decrease with heavy radio usage. If you used the nrf52, you would not need to communicate via the CPU to get voltage measurements (because the nrf52 has easy dma)

[David]

Thanks for the note, Bjorn. A lower sampling rate is fine. How do I go about synchronizing this?

[Bjørn Kvaale]

If I were you, I would take a look at one of the adc examples found on the nordic playground github page. Maybe the ble_app_uart_adc_simple example. This example basically uses UART with an added ADC functionality.