nRF Uart v2.0 not Receiving

[Nick]

I am using the eval board, sdk v5.2.0, s110 v5.0 and a galaxy nexus with the UART Nordic app. I have not been able to receive any data on the android end. After

void nus_data_handler(ble_nus_t * p_nus, uint8_t * p_data, uint16_t length)

is called i turn toggle an led. I can verifty that when i type something in my android device that it receives the message because the led will toggle. However i never get any messages back.

Much Thanks,

Nick

[Vidar Berg]

Hi, are you using a terminal on your computer to pick up the data received by your board? There is no automatic echoing implemented in ble_app_uart, so it does in other words not respond to received strings via ble. There is a startup message on the board, but it is only sent over the UART when the application starts.

Assuming that you didn't use a terminal. What you need to do is opening the corresponding com port in a terminal with 38400 baud rate and 1 stop bit.

Best regards,

Vidar

Edit: Code snippet to echo rx data to tx

void nus_data_handler(ble_nus_t * p_nus, uint8_t * p_data, uint16_t length)
  {  
      uint32_t err_code;
      /*Echo incoming data*/
      err_code = ble_nus_send_string(&m_nus, p_data, length);

      //err_code = ble_nus_send_string(&m_nus, p_data, length);
      
      if (err_code != NRF_ERROR_INVALID_STATE)
         {
              APP_ERROR_CHECK(err_code);
         }
   }

[Nick]

Much Thanks Vidar, that code you gave me worked. Thanks for all the help.