matching nrf24 to 100ohms balanced

[iot_newb]

I want to use the nrf24l01+ with the se2436 apmlifier, but the input of the amplifier requires an input of 100ohms balanced, while the nrf24 has a balanced output of 15ohm+j88ohm according to the datasheet.

Can I build a matching circuit to directly connect these to devices or is it recommended to first transform the signal to 50ohms unbalanced and then back again to 100ohms balanced.

[AmbystomaLabs]

There is a way to walk the VDD_PA signal across the match without splitting the gnd up, but then that will just give you a new set of unknowns. So, probably better to just stick with splitting the gnd.