Power Profiler Board got broken

Question

Hi, 
 I used Power Profiler Kit to measure our Custom module's current consumption. Everything worked perfectly. 
 Then I closed PPK SW and used SDK to flash new SW to one of our BLE modules/boards. During the flashing I had PPK on top of SDK. Flashing was successful. 
 But when I tried to run ppk.py SW again, it just claimed that connection issue. LED on PPK-board was not on anymore. 
 Is the PPK-board broked now? 
 How to fix it? 
 Is it not allowed to keep PPK-board on top of SDK while you are flashing? 
 Thanks and regards, 
 -kmalmiv16

haakonsh · Answer

Hey Kari, 
 I believe the PPKs nRF52 have been flashed with the FW intended for the DKs nRF52. We've all done this and there's an easy fix: 
 There's a python script in the PPK folder called 'flash_ppk.py'. Run it when the PPK is attached to the DK and it will flash the PPK's nRF52 with the correct PPK FW. 
 The reason why the PPKs nRF52 gets flashed is that the DKs on-board debugger chip is connected to it rather than the DKs. This is because the PPK data samples are routed through it. Complete the following steps in order to flash your DKs nRF52 while the PPK is attatched: 
 
 Short P22 on the DK 
 Set the Power select switch to 'External' on the PPK 
 Set the COM switch to 'EXT' on the PPK. 
 
 Reverse procedure after flashing. 
 
 We're building a new application for the PPK. It will be a plugin for the nRF Connect framework, and the user experience should be greatly improved over the old python based application. Release is scheduled for the end of the month, so keep your eyes open for our public announcements. 
 Cheers, 
 Håkon.