Unresolved symbol issue with Eclipse

[Hieu]

I have a couple of "cannot-be-resolved" issue with Eclipse.

Issue 1:

Sometime when I set up a project in Eclipse, it runs into an issue where types like uint32_t or uint8_t is unresolved.

I looked into it a little and it seems to be due lines like these:

    __STATIC_INLINE uint8_t nrf_balloc_max_utilization_get(nrf_balloc_t const * p_pool);

It seems that Eclipse cannot parse __STATIC_INLINE and therefore understood that part as declaring uint8_t type.

Is this the reason? If so, or if not so, how could I fix this?

Issue 2:

Symbols like NRF_PWM0 or TIMER1_CC_NUM could not be resolved. I have no clue about how to fix this.

Please advice me.

For reference, I have set up Eclipse according to this guide: https://devzone.nordicsemi.com/tutorials/b/getting-started/posts/development-with-gcc-and-eclipse. All of these issue have occurred during my development with SDK v10.0.0, v12.3.0 and v14.x.x.

Other than this little annoyance, most other things work just fine.

Update: I should have mentioned, I have include <stdint.h> in the case of Issue 1, and I have also set up peripherals properly in sdk_config.h in the case of Issue 2. In both case, the compiler doesn't have any complaints, the firmware generated run as intended. The issues only present in Eclipse editor.

[Abhishek Satish]

Issue 1:

You should be able to solve it by including stdint.h in your main.c file. That’s what did the trick for me. 

Issue 2:

When you use modules such as the PWM or the TIMER, you need to go to the sdk_config.h file for the project, located in the config folder, and enable the modules over there. That’ll make sure that the definitions for such things are present. 

Hope this helps!

[Hieu]

Hi Abhishek, thanks for answering.

However I did include stdint.h and enable them in sdk_config.h. The project has compiled and work fine. The problem is that Eclipse still reports errors that the compiler never encounters.

[Abhishek Satish]

Ah. Yes. Well, from my experience. That is the caveat of using Eclipse for this. :P

But after a year of struggling with it, I switched to VisualGDB. You should check it out. It is an amazingly fluent and simple experience compared to Eclipse. 

[Hieu]

Sounds interesting. I will check that out. Thanks for the recommendation.

*Update: Ah I have checked out this option before. The problem with it is that it isn't free and I could not get the budget for it. But perhaps I should consider getting a personal embedded license.

[Haaris]

I also wanted to use eclipse for this just like you because it's open source and was facing the same errors like "Symbols couldn't be resolved". SEGGER Embedded studio provides free license if you use a nordic device. 

https://www.youtube.com/watch?v=YZouRE_Ol8g&t=1s

Watch that video to get started