Timeslot with 3 advertisements

[TAR CHAL]

Hi, 

I tried to make a special  application that includes 3 advertisements, (one with softdevice, and two others with timeslot), then i successed to

integrate all the three advertisements in the application, everything is fine untill now, but the advertisements with the timeslot have no correct parameters, in fact ,

the advertisements intervals are wrong , i code the first to 1000ms and the second to 400ms but when i start the two adv at the same time, it seems 

like there is a sum of the two advertisements (1400ms for each one), i verified that with nrf connect.

Note: i have already posted this topic, but no one helped me, so i try again with this new topic.

* my starting point was "multiactivity beacon" example in the  SDK11

I will attach my timeslot code  to help you to undersand my problem. 

(SDK14.2 , Softdevice S140 V5.0.2-alpha)

thanks,

regards 

/cfs-file/__key/support-attachments/beef5d1b77644c448dabff31668f3a47-7e61e58d2936419dad0f589b1c3efee5/advertiser_5F00_beacon_5F00_timeslot.c

[MartinBL]

Remember that the scanner can only scan on one advertising channel at the time, and unless you have specifically told it otherwise, the scanner is probably not scanning a 100% of the time either. Please have a look at the third image from the top in this blog: Bluetooth Smart and the Nordic's Softdevices - Part 1 GAP Advertising. 

Furthermore, even if you are scanning a 100% of the time there is most likely going to be some radio noise in your surroundings. It could come from WiFi devices, other BLE devices, microwave ovens etc. 

If you are in a "quiet" radio environment and scanning 100% of the time, I think a 36% packet loss sounds a bit high, but you can never expect to receive all packets. 

[TAR CHAL]

thank you very much for your support.