'Play' button

[Baruch]

ble_sdk_app_blinky

Test using nRF Connect

You can also test the application with nRF Connect by performing the following steps:

1. Compile and program the application. Observe that LED 1 is on. This indicates that the application is advertising.
2. Connect to the device from nRF Connect (the device is advertising as 'Nordic_Blinky').
3. Observe that LED 2 is on and LED 1 is off. This indicates that the connections are established.
4. Observe that the services are shown in the connected device and that you can enable services for the Button Characteristic by clicking the 'Play' button.
5. Notifications are received on the Button Characteristic (0x1524) when pressing or releasing Button 1.
6. Write '01' to the LED Characteristic (0x1525) and observe that LED 3 is turned on.
7. Write '00' to the LED Characteristic (0x1525) and observe that LED 3 is turned off.

Unable to find this 'Play' button neither on the board nor on application...

PS: at the end of # 3 I have replaced "is" to are.

[Baruch]

I have the different screen

This is the example from   c:\nRF52\examples\nRF5_SDK_15.0.0_a53641a\examples\ble_peripheral\ble_app_blinky\pca10040\s132\arm5_no_packs\

[Einar Thorsrud]

The services in your screenshot is not from ble_app_blinky in the SDK, even though the name is. Can you program your board with an unmodified .hex file from the SDK to make sure you have the correct firmware on your board? You can find it under <SDK>\examples\ble_peripheral\ble_app_blinky\hex\.

[Baruch]

I sure can, but what is the point? I'm compiling and running your examples, trying to understand what is under the hood, modify them and see the results. I have no doubt that your hex is perfectly fine but it isn't what I'm after.

[Einar Thorsrud]

You tell me :) I assumed that is what you wanted to do, as large parts of your question was a copy-paste of the instructions for that example and a indication that you did not find the button for enabling notifications. If that is not what you want to do, then please let me know what you are after.

[Baruch]

 I'm compiling and running your examples, trying to understand what is under the hood, modify them and see the results. The SDK doc doesn't match with examples.