Hi
softdevice uses s130
The board is using nrf51 dk. The example uses the ble_app_beacon example from sdk12.3.
if (switch_hit ())
{
// NRF_POWER-> SYSTEMOFF = 1;
// sd_power_system_off ();
sd_ble_gap_adv_stop ();
power_manage ();
}
I measured the current by adding this part. I normally use 4.5mA, and when I enter the low power mode, it consumes 0.9mA. I thought I would spend much lower. Is this correct? Or am I making a mistake?
For reference, when I tested with system_on_wakeup_on_gpio example in GITHUB, I consumed 20uA when entering sleep mode.
I need your help.
softdevice uses s130
The board is using nrf51 dk. The example uses the ble_app_beacon example from sdk12.3.
if (switch_hit ())
{
// NRF_POWER-> SYSTEMOFF = 1;
// sd_power_system_off ();
sd_ble_gap_adv_stop ();
power_manage ();
}
I measured the current by adding this part. I normally use 4.5mA, and when I enter the low power mode, it consumes 0.9mA. I thought I would spend much lower. Is this correct? Or am I making a mistake?
For reference, when I tested with system_on_wakeup_on_gpio example in GITHUB, I consumed 20uA when entering sleep mode.
I need your help.
