nRF52 DK debug-out to Laird BL651 module

[Gavin Chung]

Hi Sir,
I am use Laird BL651 module, which use nRF52810. I am use nRF52 DK debug output (P19 and P20) connect to our board, but the nRFgo studio not able to detect device. and use Jlink command always connect to on board device (the CPU ID always same). Pretty sure wiring is correct but both port (P19/P20) are same situation.

Does anything else I do need pay attention? does nRF52 debug-out supports BL651 module? and does there has any way to test nRF52_DK debug output?

Below is error message from nRFgo studio

Thanks,

much appreciated.

Gavin

[awneil]

Gavin Chung said:

does nRF52 debug-out supports BL651 module?

The nRF52 DK - or, more specifically, its onboard JLink - neither knows nor cares anything about the module; all it sees is the chip on the SWD interface.

Have you checked with Laird if their module supports an external debugger and, if it does, whether there are any special considerations?

EDIT

Gavin Chung said:

Pretty sure wiring is correct

So post a schematic of your connection.

Have you remembered to connect GND and VDD - as well as the SWD and Reset lines ?

[Gavin Chung]

Hi Awneil,

Thanks for promp reply.

The schematic shows in below link, I was study many of your answers in DevZone.

https://devzone.nordicsemi.com/f/nordic-q-a/21659/nrf52-p19-external-programming

The SWD, VCC detect, ground and reset are connected, the our board is use local power, so VCC detect in nRF52_DEV is connect to local power of our PCBA

The BL651 support SWD interface without special considerations, do you know the way how to test my nRF52_DK debug output interface? I did measure SWD wires in oscilloscope , both are signal on it when I try to connect device. just don't know why not work.

Thanks,

Gavin

[Gavin Chung]

Hi Awneil,

Found root cause not don't know how to fix it.

The debug out not works in my desktop computer (win10) but it works in my laptop computer (win10). The cable are same and confirm nRFgo and Jlink version are exactly same too.

Any thought?

Thanks.

[awneil]

A grounding issue?

[Gavin Chung]

Hard to tell, looks no differences between PC and laptop.

And the group creation to my board and nRF52_DK is same, exactly same cable.

if assumes computer group issue then how is on board nRF52832 works properly. honestly, I have no idea. if there has anyone know how to fix it, please let me know, I do need back to working on project.

Anyway, thanks for help.

Gavin