scanning sometimes stopped

[Mikhail]

nRF52, SDK15, S132

Hi! After few days work I have stop scan from my central device on the nRF52832.

I can't to understand reason of this. But I need to know is scanning run or no at this time when device is not connected. How to do it? How to check run scan or no at this time?

[run_ar]

When calling sd_ble_gap_scan_start you can check the error message to see if scanning is started, if successfull it is ok. Please note that scanning needs to be restarted when you receive an adverisement report (This is normally handled by the scanning module).

[Mikhail]

1. What error will be returned if the scan is already running?

2. Why after receive each advertice packet I need run sd_ble_gap_scan_start  but after connected I should run scan_start with full white list initialize again.

[run_ar]

1. NRF_ERROR_INVALID_STATE

2. Not sure I understand the question. When calling sd_ble_gap_connect, you do so to connect to a known device. i.e. you either have to provide a whitelist or the address you which to connect to. While sd_ble_gap_scan_start is used to look for advertiser, can also use the whitelist.

[Mikhail]

Regarding second answer- when I call sd_ble_gap_connect, means that whitelist is already started? And at this case after each received advertise packet, I restart scan by call  sd_ble_gap_connect(). Correct?

on_adv_report(&p_gap_evt->params.adv_report);

But after connected, I need reinit whitelist by call scan_start();

My question is - between received advertise packet, thw whitelist stored and enough just call sd_ble_gap_connect? But after connect I have to call whitelist init by call scan_start();

[Mikhail]

I have second case- I need start scan for second connect when already has connected. 

after success connected I call sacn_start() and get error 

// 0x3203   BLE_ERROR_GAP_WHITELIST_IN_USE

how to start the scan, being in the connection?