Use of RF front end with Gazell.

Question

Hi there 
 I have never used a nRF51822 device but it looks like a good option for a product development. 
 Reliability of the link is a priority so the design will include a PA.
I note in previous questions the use of a PA (controlled by VDD_PA) is suggested.
Has this been tested on a physical system with proven performance gains? 
 Does the Gazell software automatically control VDD_PA? 
 This is a possible Front End

Asbjørn · Accepted Answer

There are several customers that have used the VDD_PA pin to trigger TX operation on a PA. You can't load anything from the VDD_PA pin, but you can use it as a trigger. 
 The VDD_PA pin is controlled by the HW itself. So Gazell will control it in the sense that you can control when you want to send data. As soon as Gazell use the tx send command, the chip will enter TX mode and VDD_PA will go high to 1.8 V. 
 VDD_PA will be at 0 V when it is not in TX. So RX and radio off mode, VDD_PA will be 0 V.

Use of RF front end with Gazell.

Top Replies