I have a development board and load the client central BLE blinky to it, then the peripheral BLE blinky to my custom board and power up and the central development board stays LED 1 on and never switches to LED 2.

[americanhoney]

I have a development board and load the client central BLE blinky to it, then the peripheral BLE blinky to my custom board and power up and the central development board stays LED 1 on and never switches to LED 2.  Any suggestions?

[americanhoney]

I see absolutely nothing there that addresses or can help with this situation so the RTFM reply doesnt help. additionally there only 1 single central BLE example in nRF5_SDK_15.3.0_59ac345 so the comment 'depending on the example you are using' is also not helpful.  lastly LED1 means not partnered, LED 2 means partnered (as explained by Nordic <aka you>)

https://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter.sdk5.v15.3.0%2Findex.html

[Kenneth]

Hi,

Make sure you have followed the getting started:

https://infocenter.nordicsemi.com/topic/com.nordic.infocenter.sdk5.v15.3.0/nrf51_getting_started.html?cp=5_1_1

Depending on the example you are using, the LED1 and LED2 may have different meaning. Please refer to the central and peripheral example you are using on what they mean.

Kenneth