ble_connectivity project

[DamonKelly]

I am trying to get the "ble_connectivity" project to work on the nRF52840 Dongle.

I am using a nRF52840 DK as a debugger, and SES Nordic Edition V4.16 (64-bit), with SDK 15.3

The steps I have followed are:

1. Connect to the Dongle
2. Erase the memory
3. From within SES, download the HEX file "open_bootloader_usb_mbr_pca10059_debug.hex"
4. Remove and re-insert the Dongle from the USB port (does the Reset button not function in this bootloader?)
5. The Dongle appears as "nRF52 SDFU USB (COMn)", with slowly blinking LED (so far, so good...)
6. nRF Connect v2.7.0 - Programmer finds the Dongle with Bootloader correctly
7. Using nRF Connect, I write "ble_connectivity_s140_usb_hci_pca10059.hex" to the Dongle
8. The write appears successful, but...
9. nRF Connect says:
   
   • LIBUSB error is detected. Reloading app could... etc...
10. Reloading the app doesn't help.
11. nRF Connect Programmer finds the Dongle, but selecting the device results in:
    

    1. 2019-06-21T00:17:08.815Z ERROR Error while probing usb device at bus.address 1.27: LIBUSB_ERROR_NOT_FOUND. Please check that a libusb-compatible kernel driver is bound to this device, see https://github.com/NordicSemiconductor/pc-nrfconnect-core/blob/master/doc/win32-usb-troubleshoot.md
       2019-06-21T00:17:17.505Z ERROR Unsupported device. The detected device could not be recognized as neither JLink device nor Nordic USB device.
       

12. In Bluetooth Low Energy app, selecting the Dongle results in:

    1. 2019-06-21T00:20:35.735Z INFO Validating connectivity firmware for device with serial number E22D3666FCCE...
       2019-06-21T00:20:35.737Z INFO Connectivity firmware is valid.
       2019-06-21T00:20:35.737Z ERROR Unsupported device with serial number 'E22D3666FCCE' and traits ["serialport"]
       

So, what's going wrong?

[DamonKelly]

So what is the purpose of the ble_connectivity project?

[Edvin]

It is used for serialization applications. Let us say you have a heavy application so that you need to run it on a CPU with a larger processor, but this processor/chip doesn't have a radio, then you can use the ble_connectivity to send commands over a serial interface to the nRF, which will act as a slave radio. You can check out this site.

The application that is programmed so that the chip works with nRF Connect is based off of this project, but it is not that exact one.

Did you try to program it via the tool that you want to use? Did it work with the custom bootloader?

Best regards,

Edvin

[DamonKelly]

OK, I understand.