Mesh LPN example current consumption

[Gerry]

Hi,

after setting up the LPN-example like described here I can establish a frindship relation.

When I measure the current I can not get lower than 40uA.

I use a Multimeter in DC-range, 3 nRF52840 dev. Boards, and Mesh SDK 3.1.0

What am I doing wrong?

Regards

   Gerry

[Mttrinh]

Hi,

Yes, the current consumption seems to be high. Are you running an unmodified version of the example? Have you done any modifications?

[Gerry]

Yes, unmodified, just compiled it with SES and programmed it to the PCA10056. First with the debugger connected, to see everything works well and then without debugger. I then push button 3 to establish or cancel friendship from time to time, but I never came below 40uA @ 3V

[Mttrinh]

It might be your measurement setup that is at fault. Could you describe the position of all the switches and how you have connected the multimeter?

Have a look at this post, there is a lot of info that might help.

[Gerry]

Hi,

the multimeter is connected like shown here and here

SW8 = on

SB40 is cut

SW9 = VDD

SW6 = Default

We supply with the built in coin cell. The multimeter is in DC/uA range.

Can you see something wrong in this setup?

[Mttrinh]

Hi, 

I have talked to the Mesh team and 40uA seems to be normal with LPN example. You should disable the RTT input polling to reduce the current. You can also disable GATT proxy advertising to further reduce the current.