GPIOTE input pins dont work

[LeonardPak]

Hello,

I use NRF52810 with SDK 14.2.0 and softdevice 112. I need to use 7 input pins,  but if I config more than 3 pins, all signals disappear.

GPIOTE_CONFIG_NUM_OF_LOW_POWER_EVENTS is setted to 7.
My configuration for each pins is like below:
	/**< INPUT. */
	nrf_drv_gpiote_in_config_t config_pwr = GPIOTE_CONFIG_IN_SENSE_TOGGLE(false);
	// BTN_PWR
	err_code = nrf_drv_gpiote_in_init(BTN_PWR, &config_pwr, PIN_EVT_Handler);
	APP_ERROR_CHECK(err_code);
	nrf_drv_gpiote_in_event_enable(BTN_PWR, true);

[Edvin]

Ok. And NRF_LOG_ENABLED is 0 or 1?

The reason I ask is because it sounds like somewhere in the project the application "crashes", and the most common reason is because an APP_ERROR_CHECK(err_code) receives an err_code != 0.

I don't know what HW you are testing on, but if you can connect an UART to it (if it is a DK, then it is connected to the on board Segger chip). Alternatively you can use the RTT backend if you have a segger debugger. You can use JLink RTT Viewer.

The error handler is a very useful tool while developing, and one way is to monitor it via the log. It will let you know if APP_ERROR_CHECK() receives != 0.

Another way is to define DEBUG in your preprocessor defines and set a breakpoint on line 73 in the app_error.c. But you may need to disable optimization to see what err_code it was and where it occured.

[LeonardPak]

NRF_LOG_ENABLED is set.

I can not use logging, because it`s a custom board,  and it hasnt got any external pin for uart logging and rtt logging with RTT Viewer doesnt work.

I use define DEBUG, but I havent got hard error.

Now, I trying to find mistake in the board. Maybe, it is not problem in the code.

[Edvin]

LeonardPak said:

and rtt logging with RTT Viewer doesnt work.

 Why? 

 

LeonardPak said:

I use define DEBUG, but I havent got hard error.

Do you mean that it doesn't stop on line 73 in app_error.c?

If you want to check whether it is the application that contains a bug or not, you can try your project on a DK, and just test by shorting GND to the pins that you use as input (remember to set pullup in the configuration, since the DK doesn't have external pull-up resistors).

[LeonardPak]

I dont now, why RTT Viewer doesnt work. But I find the solution! My problem is the same as this .  Now all is well.

[Edvin]

That is good news. I didn't understand exactly what the issue was. Didn't you already use toggle?

Best regards,
Edvin