nRF91 development kit ETM tracing and ETB documentation

[rabbitlennon]

Hi,

I have a nRF91 development kit  and want to connect P4 to the Segger Jtrace for ETM streaming. In the manual, it stated that a 2×10 pin 1.27 mm pitch surface mount connector can be mounted. Where can buy it and how can I mount it? In addition, since P4 and P3 share the same footprint, do I need to remove the pitch on P3 first? And how?

 

In addition, is there any documentation about the ETB support in case the tracing pins cannot be easily setup?

Thanks!

[rabbitlennon]

That's very useful. Thank you!

[Øyvind]

You're welcome! I hope solved your issue. 

Kind regards,
Øyvind