How to check nRF52840 external low frequency crystal (32kHz) is connected or not?

Question

Hi, 
 
 Using SDK 15.2.0 and SD S140_6_1_1. 
 I have two hardware of nRF52840, one has external LF crystal(32kHz) and another does not. 
 Want to run same firmware file in both hardware so Is there any way to detect external crystal is connected or not by firmware? 
 In our firmware I am using USB also. 
 
 Thanks, 
 Nirav Patel

Dmitry · Accepted Answer

Hi, if you want to use a single firmware for both boards, you can write some flag to UICR that will indicate whether LFXO is installed. If this way is inconvenient for your case, just start LFXO and wait for 0.25 sec, then check if it's not started, switch to RC: NRF_CLOCK->EVENTS_LFCLKSTARTED = 0; NRF_CLOCK->LFCLKSRC = (CLOCK_LFCLKSRC_SRC_Xtal << CLOCK_LFCLKSRC_SRC_Pos); NRF_CLOCK->TASKS_LFCLKSTART = 1; for (int cnt=0; cntEVENTS_LFCLKSTARTED) break; if (! NRF_CLOCK->EVENTS_LFCLKSTARTED) { NRF_CLOCK->TASKS_LFCLKSTOP = 1; // maybe wait some time here NRF_CLOCK->EVENTS_LFCLKSTARTED = 0; NRF_CLOCK->LFCLKSRC = (CLOCK_LFCLKSRC_SRC_RC << CLOCK_LFCLKSRC_SRC_Pos); NRF_CLOCK->TASKS_LFCLKSTART = 1; } while (! NRF_CLOCK->EVENTS_LFCLKSTARTED) ;

How to check nRF52840 external low frequency crystal (32kHz) is connected or not?

Top Replies