PCB Antenna. Tuning not necesary

Question

Hello, 
 I am designing a board based on the SoC nRF51822. Since this is a homemade project I do not have lab equipment so I can not measure antenna impedance and therefore tune it. I found this design note from Texas Instruments: 
 www.ti.com/.../swru120b.pdf 
 They claim its impedance it's 50 ohm so external components are no required. I am wondering if I can just attach output pin from balun to input pin of the antenna. 
 This is my layout and shematic 
 
 
 I added a pi-network just in case, but initially I will not mount R5 and R4. R3 will be a 0 ohm resistor. 
 Thank you.

Asbjørn · Accepted Answer

Yes, you can connect the output of the balun to the input of the antenna. You have added pi-network, but unless you are doing measurements on the antenna, just use a 0 Ohm in R3. You might have a little bit more loss than in an optimized situation, but you should still see some good range even with an antenna that haven't been optimized. 
 As you suspect, the antenna characteristics will change slightly based on size and shape of ground plane, distance to other metal parts, housing, where it's worn/used and so on. So the antenna might be tuned for a good 50 Ohm characteristics on the TI test board, but for all other application it will be slightly different. But the difference is usually not noticeable in a normal range/use case.

PCB Antenna. Tuning not necesary

Top Replies