NRF52832 Blinky example code problem.

[Ibery]

Hi I am new to NRF52832, I tested the Blinky example code but only Pin 8 and 9 work. Other I/O pins (4,5,6,7) have no response. Please help.

[Susheel Nuguru]

Would be very helpful to show us what code changes you did and what you expect the output to be on other pins (4,5,6,7)?

[Ibery]

Thanks for your reply. I just measured the voltage on the board. If I set bsp_board_led_on(2) it turns on OUT1 and bsp_board_led_on(3) it turns on OUT2. It seems that the command does not map to the correct I/O pins.

Here is my code:

pca10040.h

// LEDs definitions for PCA10040
#define LEDS_NUMBER 7

#define OUT1 9
#define OUT2 8
#define OUT3 7
#define OUT4 6

#define OUT_R 10
#define OUT_B 11
#define OUT_G 12

#define LEDS_ACTIVE_STATE 1 

#define LEDS_INV_MASK LEDS_MASK

#define LEDS_LIST { OUT1, OUT2, OUT3, OUT4, OUT_R, OUT_B, OUT_G}

main.c

int main(void)
{
 /* Configure board. */ 
bsp_board_init(BSP_INIT_LEDS);

 /* Toggle LEDs. */
while (true)
{
    for (int i = 0; i < LEDS_NUMBER; i++)
{
  bsp_board_led_invert(i);
  nrf_delay_ms(100);
}
}
}

Debugger: IAR J-Link