Can I enable reporting cluster without doing binding? [URGENT]

[Raffaela]

Hello to all,

I have a problem relating to cluster reporting: I have a device, Window Covering Device, which acts as a router and I want to connect it to Alexa, which acts as Coordinator so I have no control over its messages.

What I observe is that the binding request is not sent by Alexa so the automatic reporting of the reportable attributes in the Window Covering cluster is not enabled: the attributes are ZB_ZCL_ATTR_WINDOW_COVERING_CURRENT_POSITION_LIFT_PERCENTAGE_ID and ZB_ZCL_ATTR_WINDOW_COVERING_CURRENT_POSITION_TILT_PERCENTAGE_ID.

It is a very serious and urgent problem, so i want to know:

1) If someone had faced a similar situation
2) Is it still possible to enable reporting by sending a particular message from the router that I'm building? I had tried with the function that I found in this forum, zb_zcl_put_reporting_info, but it didn't work.

Thank you very much and have a nice day.

Raffaela

[Raffaela]

Hi,

Thank you for your help, I found the other endpoint and I used that. 

The binding is done but the reporting is not applicable: I tried to configure the reporting from the router to the Coordinator but it doesn't work. 

Am I doing something wrong?

Thank you so much,

Raffaela

[sedr]

Hello,
How did you configure reporting? Could you show the code?
Also, is the value of the attributes changing so the raporting is sent?
Did you verify that the binding is created properly? (You can verify that using CLI to remotely read the binding table)