RSSI and RSRP on THINGY.91

[Hoang]

Dear, 

Im trying to measure the RSSI with THINGY:91, I found on the document  nrf91_at_commands_v1.1.pdf about

1. AT+CSQ

      +CSQ: <rssi>,<ber>

Note: Not detectable, RAT not supported. Use +CESQ and %CESQ for E-UTRA signal quality.

2. AT + CESQ 

    +CESQ: <rxlev>,<ber>,<rscp>,<ecno>,<rsrq>,<rsrp>

<rsrp>
0 – RSRP < −140 dBm
1 – When −140 dBm ≤ RSRP < −139 dBm
2 – When −139 dBm ≤ RSRP < −138 dBm
...
95 – When −46 dBm ≤ RSRP < −45 dBm
96 – When −45 dBm ≤ RSRP < −44 dBm
97 – When −44 dBm ≤ RSRP
255 – Not known or not detectable

I am using AT+CESQ to find RSRP 

and, i found some document about RSRP range: 

https://wiki.teltonika.lt/view/RSRP_and_RSRQ

But, when I tested to measure it, i got: 

I set the devices (3) in my freezer, and got the RSRP < -100dBm, 

is it conflict here? On the document, they say: NO signal when RSRP < -100dBm, but, I measured -120dBm, and I still received the data from my THINGY:91 - it means : still signal 

I am using Telia NB-IOT( Unit1) Telia LTE-M(Unit2) and Telenor LTE-M(Unit3)

My question is: RSRP vs Signal strength range? RSRP for no signal?

Thanks 

BR, 

Hoang Nguyen

[Hakon]

Ok, try setting CONFIG_REBOOT=y in .conf and try again.

[Hoang]

I had this setting when I ran it

[Hakon]

Try sys_reboot(SYS_REBOOT_COLD) instead then. See if that works.