Dear sir,
We are using BL654PA from Laird technologies. We want to check RSSI at 2402MHz, 2440Mhz, 2480Mhz. Can you guide us how to enable PA without using Nordic stack file?
Thanks
kadam
Dear sir,
We are using BL654PA from Laird technologies. We want to check RSSI at 2402MHz, 2440Mhz, 2480Mhz. Can you guide us how to enable PA without using Nordic stack file?
Thanks
kadam
You must ask Laird what pins that controls the LNA/PA on the module in case you want to run without their SmartBasic.
Dear sir,
In BL654PA Module, We have define P1.02(SIO 34) as PA and P1.04(SIO 36) as LNA pins. We are using Nordic Radio test example code for RSSI Measurement. When we measure RSSI, we have not found any effect of PA in output power level. We are not using nordic SDK file for measurement. Can you please guide us?
Are these the pins that is used on the module to control the PA? Can you see an increased current draw when you enable the PA in TX mode? If you enable the LNA, you should see an increase in the RSSI level in RX mode when the LNA is enabled.
Dear sir,
These pins are used to control PA and LNA. During tx mode we had made PA pin High,but we have not observe any increase in current. We are using Nordic Radio test example code. Can you suggest which changes require in Nordic Radio test example code?
You must find out what pins that controls the PA/LNA and how this is done on the module. Please ask Laird about this