Unable to detect multiple light devices after provisioning on nrf Mesh application

[ggk4u]

I am trying Bluetooth mesh light-switch application on microbit, and I have flashed with same light code on multiple microbit devices, Though all the devices are getting detected in the scanner of nrfMesh android app(2.1.4v)but when provisioned the last device is overwriting the previous one and the older one is not visible in the list of devices...

And when I control it using a switch both light devices could be turned on or off, My issue is why after provisioning multiple light devices are not visble

[Joakim Jakobsen]

Hi.

That sounds strange.

Have you made sure that the Mesh app is provisioning the devices with different addresses?

[ggk4u]

Yes, the unicast address of each device is different but after provisioning only the latest is visible in the network.

[ggk4u]

Do I need to set any particular config for this?

[Joakim Jakobsen]

Ok, as long as the unicast address is different from the nodes that is being provisioned there shouldn't be any problems.

Are you able to see any logs from the provisioned devices? Are they going back to provisioning as an unprovisioned device when you provision a new device?
Do they reappear for the scanner when they disappear from your network list?

Best regards,
Joakim

[ggk4u]

No they are not getting unprovisioned, The are not listed again in scanner, I could able to control them with the switch as well, Only issue is they are not visible in the network...