Writing to UICR + software reset

[Nicholas_Nuti]

Hello,

I have a simple question. So, I'm trying to write some manufacturing information into the UICR but once I write to these addresses I can't see the device via bluetooth unless I do a hard reset. I tried using: NVIC_SystemReset(); but I was unsuccessful. Is there a way to do a soft reset so that I may see the device via a bluetooth scan without having to do a hard reset after writing to the UICR?

I need this functionality because in the future I plan on implementing DFU so that permanently enclosed devices may get updated firmware via bluetooth. When the firmware changes, the information in the UICR will change and I will have no way of hard resetting these enclosed devices. I.E. these enclosed devices become useless if I change the UICR information in the current case.

Thank you,

Nick

[Nicholas_Nuti]

Hi Einar,

Einar Thorsrud said:

Some of the registers in the UICR are only read after reset, so a change in those need a reset for it to take effect.

Thanks for the information! Im hoping that the registers that I'm using wont require a reset; do you know which do need a soft reset?

Einar Thorsrud said:

If you just write your own user data to available registers (typically serial number or similar), then there is no need to reset, and you can read the data back immediately after as you could any other flash region.

That's great to hear.

Thank you for the info,

Nick

[Einar Thorsrud]

Hi Nick,

Nicholas_Nuti said:

Thanks for the information! Im hoping that the registers that I'm using wont require a reset; do you know which do need a soft reset?

All the UICR registers that configure HW, which are those with an offset of 0x200 or higher require a reset to take effect since it is only read during startup.

Einar

[Nicholas_Nuti]

Hi Einar,

Ultimately, I think this is what I wanted to know. Thank you so much for the helpful information!

Thank you,

Nick