nRF Connect SDK Tutorial - Part 3 | NCS v1.3.0 --> 1.2 Walkthrough for BME280 - gives compilation error

[ChandraSR K]

I am trying to repeat the example in the tutorial: using board: nrf9160dk_nrf9160.

nRF Connect SDK Tutorial - Part 3 | NCS v1.3.0 --> 1.2 Walkthrough for BME280 -  but gives compilation error

2> ../src/main.c:17:2: error: #error Your devicetree has no enabled nodes with compatible "bosch,bme280"

I couldn't figure out and can you help on how to resove this.

Thanks

Chandra

[ChandraSR K]

Hi

either one of the below address the issue,

&uart1 {status = "disabled";}; -- > adding in nrf9160dk_nrf9160ns.overlay

OR

CONFIG_SERIAL=n   --> addign in prj.conf

But I would be needing serial port as well for printing info. above statements doesn't allow me to print debug messages.

[ChandraSR K]

Hi Can you suggest here.

[Håkon Alseth]

Hi,

 

My apologies for the late reply.

ChandraSR K said:

&uart1 {status = "disabled";}; -- > adding in nrf9160dk_nrf9160ns.overlay

This will disable UART1, but keep UART0 (default used for printing) still enabled. You should not disable CONFIG_SERIAL, as this will disable the uart debug prints as well.

 

Kind regaerds,

Håkon