Trying to send something over UART

[MarieMaurer]

Hello,

I am trying to send something by my own via UARTE0. This is only for testing/learning purposes:

    uint32_t enable0 = NRF_UART0->ENABLE;
    NRF_LOG_INFO("enable(UART0)=%d", enable0);

#if 1
    {
        uint8_t hello_world[] = "Hello\r\n";

        // Configure transmit buffer and start the transfer
        NRF_UARTE0->TXD.MAXCNT = sizeof(hello_world);
        NRF_UARTE0->TXD.PTR = (uint32_t)&hello_world[0];
        NRF_UARTE0->TASKS_STARTTX = 1;

        // Wait until the transfer is complete
        while (NRF_UARTE0->EVENTS_ENDTX == 0)
        {
        }
        // Stop the UART TX
        NRF_UARTE0->TASKS_STOPTX = 1;
        // Wait until we receive the stopped event
        while (NRF_UARTE0->EVENTS_TXSTOPPED == 0);
    }
#endif // 0

    uint32_t pseltxd0 = NRF_UART0->PSELTXD;
    uint32_t pselrxd0 = NRF_UART0->PSELRXD;

    NRF_LOG_INFO("pseltxd(UART0)=%d pselrxd(UART0)=%d", pseltxd0, pselrxd0);

    enable0 = NRF_UART0->ENABLE;
    NRF_LOG_INFO("enable(UART0)=%d", enable0);

This is what I see:

[00:00:00.000,000] <info> app: enable(UART0)=8
[00:00:00.000,000] <info> app: pseltxd(UART0)=7 pselrxd(UART0)=-1
[00:00:00.000,000] <info> app: enable(UART0)=8

I see NRF_LOG_INFO output before and also afterwards. I have ...DEFERRED off.

Do I need something else to send over NRF_UARTE0?

Many thanks!

Best regards,

Marie

[MarieMaurer]

The final goal would be to have debug output via UART in secure dfu bootloader and still fit in size restrictions. It would be enough to send some characters or strings. Don't need buffering of output. But I want to see which pathes are taken through bootloader or what error conditions occure. I need to see this via UART, because JTAG is not available widely. UART could be possible, if something is not working as planned.
Note: The above tests were done in application code, just to learn how to deal with UART.

[MarieMaurer]

Where can I find implementation of NRF_LOG_INFO,

especially the version which sends something over UART in non-deferred mode?

Does it enable something (clocks, power, ...) before sending some characters

and switching it off, when everything was sent out?

[MarieMaurer]

Found the problem with the second code, which is using UART0 (not UARTE0!):

NRF_UART0->BAUDRATE = (115200 << UART_BAUDRATE_BAUDRATE_Pos); //WRONG!!!

must be

NRF_UART0->BAUDRATE = 0x01D7E000;

or

NRF_UART0->BAUDRATE = (UART_BAUDRATE_BAUDRATE_Baud115200 << UART_BAUDRATE_BAUDRATE_Pos);