Softdevice asserts in release configuration flashed by SeS

[Mikl Scherbak]

I'm using Softdevice S132 V 7.0.2 with nrf52832 module. Project is in Segger Studio. Project runs in debug configuration as in debug or in non-debug mode. When changing to the release configuration and load it in debug mode it stops at 0xa64. Resetting the device makes it run normally.

[Jørgen Holmefjord]

Hi,

Have you debugged the application to see where the assert happens?

Which SDK version are you using?

Can you upload the project, for us to have a look at the differences between the build configurations?

Best regards,
Jørgen

[Mikl Scherbak]

Assert happens in sd_softdevice_enable called from nrf_sdh_enable_request. SDK is 16.0. I can not upload the whole project due th NDA but can upload .emproject if needed.

[Jørgen Holmefjord]

Ok, lets start with the .emproject file and see what we can get from that.

After a reset, the device is able to pass the sd_softdevice_enable function call, even in release configuration?

[Mikl Scherbak]

Yes, after reset or flashed by j-flash light it works normally build in release configuration. I could not insert a file so here is a link to it .emproject

[Jørgen Holmefjord]

Your link say I need to request access. Can you send me the file in a PM here on DevZone, or provide a link with direct access?

I can also convert this ticket to private, in case you do not want to share the file in public forum.