Mesh not working after reconnecting USB

[Natael]

Hello guys,

I am developing a BLE Mesh app with nRF52833DK. However, I have recently discovered a problem. It stops working the Mesh iI disconnect USB and then I Connect It. So the only solution I see is to provision them again. But this dont have any sense. 

How could I restore the funcionality develop?

Thank you,

Best regards :)

[Carl Richard]

Hello again!

Apologies for the delayed answer on your case. A colleague pointed out that there may be differences in priorities between the BSP and HAL libraries that could interfere with normal mesh operation. Could you have a look at the documentation for Setting interrupt priority levels and see if the application is within the guidelines?

Best regards,
Carl Richard

[Natael]

Okey thank. Finllay i resolved the problem. Thank you for all :)

[Carl Richard]

Good to hear! It's our pleasure.

Best regards,
Carl Richard