nRF52833 GPIO behavior during pin reset

[Pascal Künzi]

Hi guys

Could you tell me the expected pin states while the nRF52833 is kept in reset with the pin reset?

For the nRF52840 i have found this devzone entry:

It basically states, that the pins will be configured as input disconnect.

As experienced with the nRF52832, the pins seem to be all configured as input disconnected while the pin reset is asserted.
Thus, we would have expected the same behavior on the nRF52833.

Yet, in this devzone entry of the nRF52840, following is stated:

"When reset pin is pushed the pin behavior is undefined, it may be output or floating. It is not much that can be done about this other than ensure that the pin reset is pushed for a short period of time as possible, for instance >0.2us is sufficient to ensure a hardware reset."

Having pins randomly configured as output and driving unknown circuitry seems critical.

I haven't checked the behavior on all pins but the configured UARTE TX pin is driven low for as long as the pin reset is asserted.

Do pins configured for certain peripherals lead to different pin states during a reset?

I hope you can help me clarify this.

Thank you in advance!

Regards,
Pascal

[Pascal Künzi]

Hi,

Thank you for looking into this.

Could you also give me an answer to the two questions below.

• Any chance this will be fixed in a future silicon revision?
• Will this behavior be documented?

Depending on the connected cirtcuitry, this should at least be documented to mitigate possible problems with this behavior.

Thank you for your help!

[run_ar]

Hi,
We do not have any specific plans to change this as of now. But this might change in the future.

Still discussing if and how this should be documented. Have you made any observation that indicate that the GPIO state change to something else during reset pin low than?

1. Default reset state 
2. The current state before entering reset

[Pascal Künzi]

Hi,

Thank you for the update. I guess we have to live with that for now. Let me know, once there is more information available.

No, so far I have only observed the behaviour mentioned above.

[run_ar]

I'll answer the case for now to get it off my todo list. But I will update the case if I get more information from the IC development group. I am sorry for the inconvenience.

[Bertram]

Observed on NRF52840 that pins used by the PWM peripheral are output low while reset pin is low.

This is independent of the pin state before reset (e.g. pin is controlled by PWM, but high at the time of reset, and then stays low while reset is held low).

Easily observable since LEDs connected to 3V3 and an NRF52840 PWM pin always turns on when reset is held low.