multilink example in nrf52810

Question

Hi, 
 is it any possibilities to multilink central with s112 in nrf52810 chip? 
 
 using sdk: sdk14 
 actually, i am using sdk14 with one central and one peripheral is fine, is any possibilities with s112 one central at a time connected two peripherals? 
 otherwise is any possibilities multilink with s112(nrf52810)?

Thanks, 
 naren

ovrebekk · Accepted Answer

Hi Naren 
 Are you able to share your sdk_config.h file with me so I can take a look at all the configuration settings? 
 Have you considered using a more up to date SDK than SDK v14? 
 Best regards Torbjørn

ovrebekk · Answer

Hi Naren 
 You are saying that connecting to exactly the same 1 central and 1 peripheral doesn't work when you increase the central link count to 2? 
 Did you make sure to also increase the total link configuration? 
 Best regards Torbjørn

narendar · Answer

Thanks for reply, I am setting to NRF_SDH_BLE_CENTRAL_LINK_COUNT=1 ,it is working fine for ( 1 central and 1 peripheral )connection is fine(data also sending),but i am changed to NRF_SDH_BLE_CENTRAL_LINK_COUNT=2 for (1 central and 1 peripheral) it gets fatal error like these 0> app: scan_start 0> app: Connecting to target C2:DF:94:57:17:D1 0> app: p_ble_evt->evt.gap_evt.conn_handle : 0 0> app: scan_start ret:0 0> 0> app: scan_start 0> app: Discovery complete. 0> app: Connected to device with Nordic UART Service. 0> app: Active Connection = 1 0> app: scan_start ret:8 0> 0> app: scan_start 0> app: Fatal error 0> Here error gets NRF_ERROR_INVALID_STATE whenever NRF_SDH_BLE_CENTRAL_LINK_COUNT incremented.

multilink example in nrf52810

Top Replies