Failing to flash PCA10040 nRF52 DK using J-Link

[Dimi-zh]

Hello, 

I encountered a problem while trying to flash my PCA10040 nrf52 development kit.

I am able to compile my code in Segger Embedded Studio without a problem. The chip has 512kB of flash and 24kB which should be more than enough to flash the chip.

Then I start flashing and I get this error message

When I look at the log I see this

If someone can help I would greatly appreciate it. I am open to provide with more information if something is missing.

[Dimi-zh]

Hello, 

i installed the nRF connect for desktop and the programmer v2.0.1

From there i loaded my hex file into the prigrammer and i uploaded it to the nRF5 dev kit. 

The operation seems to have worked. 

What can I do after I successfully upload the hex file. 

How can I proceed with the debugging?

 

[Kenneth]

I suggest to check out:
https://infocenter.nordicsemi.com/topic/ug_gsg_ses/UG/gsg/intro.html 

Youtube tutorial:
https://www.youtube.com/watch?v=uP8RYgYGRvI&list=PLx_tBuQ_KSqGHmzdEL2GWEOeix-S5rgTV&index=7 

nRF5 SDK:
https://infocenter.nordicsemi.com/topic/sdk_nrf5_v17.1.0/nrf51_getting_started.html 

Best regards,
Kenneth

[Dimi-zh]

Thank you,

I will look into these !